Worx WX473, Инструкция по безопасности и эксплуатации

Страница: 12 / 17

Jigsaw WX473 WX473.1 WX474
6. BLADE FITTING
You can only use the blade type shown in Fig D. To
open the blade holder (11) rotate the ring clockwise
(Jigsaw upside down) and hold in position
(See Fig. E). Then fully insert the blade into the blade
holder slot with blade teeth facing forward and release
the ring, which will self rotate and clamp over the top
of the blade. Push the blade into the blade holder again
to ensure it is locked in position. Ensure the edge of the
blade is located in the groove of the blade guide
(See Fig. F). To remove a blade, holds the blade and
rotate the blade holder ring clockwise then lift out the
blade (blade could be spring ejected).
WARNING: Blade teeth are very sharp.
For best cutting results ensure you use a blade
suited to the material and cut quality you need.
7. PARALLEL GUIDE FIXTURES
Slide the parallel guide (7) arm through both fixtures to
achieve the required cutting distance and tighten both
screws to lock into position.
8. BLADE GUIDE
Ensure the blade is located and runs smoothly in the
groove (See Fig. F) otherwise the pendulum function
will not work correctly and the blade will not be
supported during cutting.
9. PENDULUM ACTION CONTROL
The pendulum action varies the forward cutting angle
of the blade for increased cutting efficiency. This can
also be adjusted during no load running. Refer to the
chart 2 for more details. Do not use excessive blade
force when cutting with the pendulum action. The blade
cuts on the upward stroke only (See Fig. G).
Chart 2
0 Thin materials. Fine cuts. Tight curves.
I
Hard materials, (e.g. steel & chipboard)
II
Thick materials (e.g. wood) & plastic
III
Fast cuts (e.g. softwood). Cutting in the
direction of the wood grain.
10. BASE PLATE
Adjusting the angle of the base plate (13) enables bevel
cutting. The base plate must always be held firmly
against the materials being cut to reduce saw vibration,
blade jumping or blade breakage.
1 2
1
2
A
B
C
D
E
F
G
H