Worx WX473, Инструкция по безопасности и эксплуатации

Страница: 14 / 17

Jigsaw WX473 WX473.1 WX474
16. LASER GUIDE (Only for WX474)
Depress the laser on/off switch button (20), the laser
device can provide a beam in the same plane as the
blade, which projects onto the work piece to generate
a line. The saw blade can be directed to follow the line
in order to align the cut with the line. Either straight
cutting or bevel cutting, it will make more precise
movement during cutting.
WORKING HINTS FOR YOUR
JIGSAW
If your power tool becomes too hot, especially when
used at low speed, set the speed to maximum and
run no Load for 2-3 minutes to cool the motor. Avoid
prolonged usage at very low speeds.
GENERAL
Always use a blade suited to the material and material
thickness to be cut. Always ensure the work–piece is
firmly held or clamped to prevent movement. For easier
control, use low speed to start cutting, then increase to
correct speed.
Any movement of the material may affect the quality of
the cut. The blade cuts on the upward stroke and may
chip the uppermost. Ensure your uppermost surface is
a non-visible surface when your work is finished.
CUTTING LAMINATES
Use a fine tooth blade when cutting most laminates
and thin wood materials. To reduce edge chipping,
clamp pieces of waste wood at both ends on both sides
and cut through the wood during cutting.
CIRCLE CUTTING
Do not use the pendulum action when cutting tight
circles or angles.
PLUNGE SAWING
Plunge cutting may be used only on soft materials such
as wood, aerated concrete, gypsum plaster boards, etc.!
Use only short saw blades.
Place the front edge of the base plate on the workpiece
and switch on. Press the machine firmly against the
workpiece and plunge the saw blade slowly into the
workpiece.
As soon as the complete surface of the base plate rests
on the work piece, continue to saw along the cutting
line. (See Fig. M,N)
I
J
K
L
M
N