WORMS ACCESS 3400, Инструкция по эксплуатации

Страница: 11 / 36

EN
FR
ES
IT
RO
11
3. Let the battery rest for a while (roughly 1/2 HRS) before running by a load. If the electrolyte level
dropped, fill again until the maximum level.
4. If necessary, reload the battery. The loading can be made with unscrewing the filling caps.
5. Remove the plugs and clean the electrolyte that fell down on the battery. The battery is ready for use.
ABOUT THE BATTERY CABLES Fig.
5
1. Fix the positive (+) wire connected to the electrical starter to the positive terminal of the battery.
2. Fix the negative (-) wire connected to the housing of the engine to the negative terminal of the
battery.
5. OPERATING PROCEDURES
Check the oil level before each operations as outlined on page 9. Never change the accelerator
position which is set at the factory.
5.1. STARTING THE ENGINE
1. Turn the engine switch to the position « I » (ON). Fig.
6
1
2. Open the fuel cock. Fig.
6
2
3. Pull the choke knob to close if the engine is cold. Fig.
6
3
[RECOIL STARTER MODEL] Fig.
7
1
•
Pull the starter handle slowly until resistance is felt. This is the «compression» point. Return the
handle to its original position and then pull swiftly.
If the engine fails to start after several attempts, repeat above procedures with choke knob returned to open.
•
Do not fully pull out the rope.
•
Après le démarrage du moteur, la corde du lanceur doit retrouver sa position initiale. Pour cela accompagner
la poignée jusqu’au lanceur.
•
After the engine started, return the choke knob gradually to “OPEN” position.
•
Warm up the engine without a load for a few minutes.