45
EN
5. Pull the starter handle slowly until resistance is felt. This is
the «compression» point. Return the handle to its original
position and then pull swiftly.
•
Do not fully pull out the rope.
•
After starting, allow the starter handle to return to its
original position while still holding the handle.
Starter Grip
6. When the engine is warm, return the choke knob gradually
to “OPEN” position.
7. Warm up the engine without a load for a few minutes.
You can not use your electric equipments as long as the AC circuit breaker is on
“ON” position.
8.2. UsiNg ELEctric poWEr
Ac AppLicAtioN
This generator is thoroughly tested and adjusted in the factory. If the generator does not produce the
specified voltage, consult your nearest Worms dealer or service shop.
Turn off the switch of the electrical appliance(s) before connecting
to the generator.
Insert the plug of the electrical appliance into the receptacle.
Be sure to ground the generator if the connected electrical device is
grounded. Failure to ground unit could lead to electrical shock.
•
Check the amperage of the receptacles, and be sure not to take a current exceeding the specified
amperage.
