Worldwel Longrun 500LMP, Руководство по эксплуатации

Страница: 7 / 9

value data by turning the volume (1). When modifying P05 and P06, move to the percentage
value with the F2 button and you can change the data by the volume (1)
■ Hidden data adjustments / modifiable data items
No Item Setting range Minimum Reset Factory set
P01 Burn back time 0.01-2.00s 0.01s 0.08s 0.03s
P02
Motor speed on open circuit
voltage
1.0-21.0M/min 0.1M/min 3.0M/min 3.0M/min
P03 Pre-flow time 0.1-10.0s 0.1s 0.20s 0.20s
P04 Post-flow time 0.1-10.0s 0.1s 1.0s 2.0s
P05 Start current 1-200％ 1％ 135％ 100％
P06 Crater current 1-200％ 1％ 50％ 30％
P07 Up-down slope time 0.1-10.0s 0.1s 2.0s 2.0s
P08 Spot time 0.5-5.0s 0.1s 2.0s 2.0s
P09 Remote control on/off OFF/ON OFF OFF
P10 Water cooling on/off OFF/ON ON OFF
P11 Double pulse frequency 0.5-5.0Hz 0.1Hz OFF 3.3
P12 Double pulse arc length -50-+50 1 0.0 1.0
P13 Double pulse speed 0-2m 0.1m 2.0m 2.0m
P14 Double pulse width 10-90% 1% 50% 50%
P15 Single pulse frequency OFF/UI/UU/II OFF UU
P16 Fan delay time 5-15min 1min 15min 15min
P17 Up-slope time 0-10S 1S OFF 0.1
P18 Down slope time 0-10S 1S OFF OFF
P19
Synergic / Individual mode
on/off
OFF/ON ON ON
Note: If you press the volume (1) for about 3 seconds, the welder will be set to the initial state.
If an error occurs during operation, the welder is automatically protected and the error code is
displayed on the digital window with the code number.