220W 3-in-1 Multi Purpose Sander
AFTER SALES SUPPORT
e-mail: [email protected]
1800 909 909
MODEL No.: S1B-DW01-220W • 09/2018 • 61865
(toll free)
AFTER SALES SUPPORT
(toll free)
220W 3-in-1 Multi Purpose Sander
e-mail: [email protected]
1800 909 909
MODEL No.: S1B-DW01-220W • 09/2018 • 61865
12
13
5. To fit the triangular sander plate (11), first
ensure the tip of the plate points forwards
(Fig D).
6. Using the additional supplied 4 x rubber pins
(15), prepare the base by inserting the
4 x rubber pins into the 4 x holes on the
triangular sander plate (Fig E).
7. Ensure that the sander drive plate on the
sander is aligned with the triangular sander
plate such that the threaded holes of the
sander drive plate are aligned with the
mounting holes on the triangular sanding plate
(11) (Fig F).
8. Push the triangular sander plate (11) on to the
sander drive plate so the rubber pins engage
with the holes on the sander housing, and
using the 4 x washers supplied in
a separate bag, screw them in to secure the
triangular sander plate into place onto the
sander drive plate (Fig G).
9. Ensure the screws are tightened before use.
There is no pre-assembly required, other than fitting the base required
for first use. The Sander is fitted with the rectangle sander plate (9). For
changing the sander plate to the triangular sanding plate (11), or the
random orbit sanding plate (13), refer to the following instructions.
Fitting/changing the sander plates – Triangular Sander Plate
Changing from the fitted rectangle sander plate (9) to the triangular sander
plate (11).
WARNING! Always remove the plug from the mains power socket
before carrying out any work on the sander.
1. Always use the appropriate sander plate (9) / (11) / (13) for the correct
application required.
2. Using a philips head screwdriver (not supplied), remove the four screws
(12) visible on the underside of the rectangle sander plate (9) in an
anti-clockwise direction (Fig A).
3. Once the 4 screws are all loose, remove the pre-fitted rectangle sander
plate (9) (Fig B).
4. For re-fitting the rectangle sander plate (9), follow the instructions in
reverse order.
NOTE: The rectangle sander plate (9) can only be fitted to the sander in
one direction. Please pay attention to the arrow marks on the rectangle
sander plate (9) when doing this. These must point forwards (Fig C).
Assembly
Assembly
Assembly
C.
A.
B.
F.
D.
E.
G.
LOOSEN
TIGHTEN
4 X