7. SYSTEM ASSEMBLY
Figure 7.4: Connecting GIS 320 using USB On‐The‐Go
Warning
: Do NOT connect GIS 320 to any other powered device (such as PC) through the full size USB
port on the rear of GIS 320 ‐ only the side Micro USB port can be used for mass storage access. As the
rear USB port is powered, connection to another powered USB port can lead to permanent damage to
either device.
Warning
: Do NOT format the SSD of the camera as a device connected to the PC via USB OTG! Formatting
the SSD in this manner will void the warranty and the camera will need to be sent for repair. Use only the
firmware GUI of the camera to format the SSD, while the camera is not connected to any other device.
7.6 SD Card
The Workswell GIS 320 can be optionally fitted with a MicroSD memory card as a storage medium. Most generic
MicroSD cards should be compatible. Video recordings cannot be saved directly to the MicroSD card and have
to be recorded only to internal storage (but can be moved over to the MicroSD off‐line within the device itself).
To install the MicroSD card simply insert it into the MicroSD slot on left side of the device. Be mindful of the
SDCard orientation; contacts should be facing upwards.
The MicroSD card should be recognized by the device even if inserted with the system already running. The
MicroSD card should only be removed with the device either unpowered, or after the SD card is manually
unmounted in the Memory menu.
7.7 Power Supply
The Workswell GIS 320 system can be powered through a +10 to +28 VDC connector on the back panel. The back
panel DC connector is compatible with a 5.5 mm/OD (outer diameter) and 2.5 mm/ID (inner diameter) plug,
where the inner contact is +10 to +28 VDC and the shell is GND.
E‐mail and Web
[email protected]
www.workswell.eu
Mobile:
+420 725 877 063
ID:
Reg. No.: 29048575
VAT No.: CZ29048575
Headquarters
U Albrechtova vrchu 12
155 00, Prague 13
Czech Republic
Revision 210427 EN, 27
th
Apr, 2021
All pictures are only for illustration.
Real values may vary.
15
