Worksaver 614HC, Руководство владельца/оператора

Страница: 14 / 31

13
WARNING
CAUTION
CAUTION
The eight models of hydraulic post hole diggers are
designed to meet the various mounting applications
requested by customers.
Tractor must be equipped with stabilizer bars,
adjustable sway chains, or sway blocks to keep the post
hole digger from swinging side to side.
Smaller size tractors may need front counter weights to
counter-balance the weight of the post hole digger and
the weight of the dirt on the auger (when using large
diameter augers).
Check the tractor’s 3-pt. hydraulic lift system. It should
operate up and down smoothly and have enough power
to lift the dirt-loaded auger out of the hole. Refer to your
tractor operator’s manual or dealer for any adjustments
necessary to put the 3-pt. hydraulic lift system in good
working order. (I&T shop manuals will list most specifica-
tions and adjustment instructions - available from most
farm equipment dealers.)
MODELS 614HC and 624HC are 3-pt. mounted post
hole diggers that will fit most Category I and Category II
tractors equipped with a standard 3-pt. hitch.
MODELS 814HC and 824HC clamp-on to tractor front
loaders or skid steer loader buckets.
MODELS 714HC and 724HC use a bolt-on mounting
plate that are designed primarily for bolting on to the end
plates of a front loader bucket, but are adaptable to other
mounting applications.
The post hole diggers are easily installed or removed
from your front loader in minutes. A chain and turnbuck-
le provide a secure, easy means of clamping the attach-
ment to your loader bucket.
It is recommended that only tractors with wide front
axles be used with this implement. Tricycle front wheel
arrangements are inherently unstable and tractor roll-
over accidents are more likely to occur.
• Be sure your tractor or skid steer is in good
condition. Read all the safety precautions and make
sure all operators are familiar with the safety rules of
operation.
• The use of any loader attachment is NOT recom-
mended on tractors with a tricycle wheel arrange-
ment. Tricycle type tractors are unstable for front
loader use.
INSTRUCTIONS
TRACTOR AND LOADER
REQUIREMENTS AND
PREPARATION
Check the hydraulic system. Be sure the hydraulic oil
and filter have been serviced according to the manufac-
turer’s recommendations.
NOTE: Models ending with 14HC are for 5-10 gpm
systems @1500-3000 psi.
NOTE: Models ending with 24HC are for 10-20 gpm
systems @1500-3000 psi.
The required size of the tractor and front loader or skid
steer will be determined by the weight of the load to be
handled.
Always use a tractor and front loader or skid steer large
enough to safely handle the load.
ALL MODELS
A heavy load can cause instability in driving a
tractor. Make sure the front or rear of the tractor is
properly counter-balanced with weights. Always
drive slowly – especially around turns. An unstable
tractor could steer badly and possibly tip over,
causing injury or death.
Check your tractor and front loader or skid steer to make
sure they are in good working condition. Check all frame
mounting bolts to make sure they are tight.
Loaders that attach to the tractor frame rails should
have a cross-tie installed for stability.
MODEL 914HC and 924HC are for mounting directly on
skid steer units or tractor front loaders with the universal
quick-attach bucket mount.
The bucket is removed and a separate post hole digger
mounting frame is used.
Power unit must be equipped with ROPS or ROPS
cab and seat belt. Keep seat belt securely fastened.
Falling off power unit can result in death from being
run over or crushed. Keep foldable ROPS systems in
“locked up” position at all times.