Worksaver 614HC, Руководство владельца/оператора

Страница: 13 / 31

12
SAFETY SIGNS
(continued)
LOCATED AT TOP OF AUGER CENTER TUBE
REMEMBER:
If Safety Signs have been damaged, removed, become illegible or parts replaced without Signs, new
Safety Signs must be applied. New Safety Signs are available from your authorized distributor or factory.
BE CAREFUL!
Use a clean, damp cloth to clean safety decals. Avoid spraying to close to decals when using a pressure washer;
high-pressure water can enter through very small scratches or under edges of decals causing them to peel or come
off.
HOW TO INSTALL SAFETY SIGNS:
Be sure that the installation area is clean and dry.
Be sure temperature is above 50°F (10°C).
Decide on the exact position before you remove
the backing paper.
Remove the smallest portion of the split backing
paper. Align the sign over the specified area and
carefully press the small portion with the exposed
sticky backing in place.
Slowly peel back the remaining paper and careful-
ly smooth the remaining portion of the sign in
place. Small air pockets can be pierced with a pin
and smoothed out using the piece of sign backing
paper.
101358