8
SAFETY INSTRUCTIONS
(continued)
OPERATIONAL SAFETY (continued)
Stop loader gradually when lowering or lifting loads. Operate loader controls smoothly, avoid jerky operation.
Operate loader from operator’s seat only. Remain at controls until operating cycle is complete.
Allow for additional length of loader and attachment on power unit while turning.
Be sure that people, livestock, or pets are not standing near the machine while operating.
Only use a power unit equipped with a ROPS cab or rollover protective structure. Keep foldable ROPS sys-
tems in “locked up” position at all times.
Do not lift or carry anyone on loader or in bucket or on attachment. Do not use loader for a work platform.
ALWAYS lower loader to the ground or block securely before performing any maintenance work.
Use extreme care and maintain minimum ground speed when transporting on hillside, over rough ground and
when operating close to ditches or fences. Be careful when turning sharp corners.
Stay alert for holes, rocks and roots in the terrain and other hidden hazards. Keep away from drop-offs.
Reduce speed on slopes and sharp turns to minimize tipping or loss of control. Be careful when changing
directions on slopes. Do not start or stop suddenly on slopes. Avoid operation on steep slopes.
Keep hands, feet, hair, jewelry, and clothing, away from all moving and/or rotating parts.
To prevent entanglement and possible serious injury or death, never use body weight to try to push auger into
the ground.
Do not shovel dirt away from a rotating auger as the shovel can be caught and thrown by the auger.
Avoid excessive speed during operation.
Always shut off power unit and shift to “Park” or set brakes when leaving power unit. Always lower bucket or
attachment to ground. Remove key when leaving power unit unattended.
Before operating equipment: if you have any questions regarding the proper assembly or operation, contact
your dealer or representative.
Содержание 614HC
