WORKMASTER TO-A02, Руководство пользователя

Страница: 16 / 28

12
PH: 866.476.9217
VII. STORING YOUR TO-A02 TRAP OPENER
1. Shut-off the pressurized air to the FRL by turning off the air to the FRL Unit.
2. Bleed-off the stored air in Tool and hoses by depressing the trigger switch in
either direction.
3. Disconnect the supply hose from the FRL Unit, and disconnect the air hose at the
TO-A02 Opener.
4. If the TO-A02 Opener is not to be used for an extended period of time, spray
pneumatic lubricating oil into the TO-A02 's Inlet Fitting. Reconnect the air hose
and supply hose to the FRL Unit's air inlet fitting. Cycle the FRL unit momentarily
to ensure that 2-3 drops of lubricating oil has entered into the Tool's air motor.
Then stop and shut-off the system as previously stated above in steps 1, 2, 3.
5. Store your TO-A02 Opener and all components and accessories in the storage
bag that it was shipped in.
IMPORTANT
Repairs should be made only by authorized personnel.
Consult AIRMATIC, WORKMASTER ’s Authorized
Service Center. The use of other than genuine
WORKMASTER replacement parts may result in
safety hazards, decreased tool performance, increased
maintenance, and may invalidate all warranties.