6
7
3730 E. SOUTHERN AVE., PHOENIX, AZ 85040 | USA
800.778.8779 | WORKHORSEPRODUCTS.COM
DRYER COMPONENTS
ASSEMBLY
STEP 1: UNCRATING
Remove shrink wrap. Carefully remove
the infeed and exit arms off the crate.
*If removing the dryer with a
forklift place the forks through
this side of the dryer.
The hardware box contains:
(4x) Hex Bolt (3/8-16 x 3/4”)
(4x) Flanged Nuts (3/8-16”)
(4x) Flat Washers
(4x) Hex Bolt (3/8-16 x 3/4”)
(4x) Flanged Nuts (3/8-16”)
(4x) Flat Washers
(1x) Belt
(1x) Threading Pin
1.
2.
PANEL HEATING ELEMENTS
Underneath the top panel there are
three infrared radiant panel heating
elements that are controlled by the
tablet controller. They can cure plastisol,
water-based ink and any evaporative
cured ink. They are capable of heating
up and cooling down within seconds.
CRANK HANDLE
Used to raise and lower the heating
elements to adjust heat distance to
the garment. To raise the element
turn the crank handle clockwise. To
lower the element turn the crank
handle counterclockwise.
FILTERED INTAKE
Filters the incoming air
and needs to be cleaned
whenever it becomes filled.
EXHAUST
The exhaust is used to
release heat. Use the
push pin handle next to
the exhaust to control the
amount of heat released.
E-STOP
Emergency Stop
OUTFEED
Where the garments exit
the curing process. They
land on a cool down
table and eventually run
off the belt.
REAR PULLEY
The pulleys
are created for
precise rolling at
an even center.
BELT TRACKING ADJUST
Used for tracking the belt
and keeping the belt on the
pulley. If the belt moves to
the side, use the belt tracking
adjust to center it.
CONVEYOR BELT
The conveyor belt is created
of Teflon coated fiber glass
and is placed on a self-aligning
belt tracking system. The belt
is designed to withstand heat,
but be sure the belt is always
moving when the Powerhouse II is
operating above 300 degrees.
TABLET CONTROLLER
The tablet controller is the main control
system for the Powerhouse Series II. The tablet
programs the temperature, belt speed, warm
up, cool down, power consumption, create
presets, access the owner’s portal, and contacts
Workhorse technical support if ever needed.
CONTROL BOX
Most of the machine’s
electrical components
are located within the
control box. This box is
easily accessible for any
necessary maintenance.
CONVECTION SYSTEM
A precisely designed air
system to utilize and release
heat within the dryer.
INFEED
Where the garments
are placed to start the
curing process.
FRONT PULLEY
The pulleys are created
for precise rolling at an
even center.
