10
11
3730 E. SOUTHERN AVE., PHOENIX, AZ 85040 | USA
800.778.8779 | WORKHORSEPRODUCTS.COM
ASSEMBLY
STEP 4: INSTALLING & TRACKING THE BELT
On the side of the dryer with the
tablet, locate the infeed roller.
Remove the top nut and bolt
holding the infeed roller in place.
Then loosen the bottom nut, but
keep in place.
After loosening the bottom nut, roll
the infeed roller forward so there
is less tension on the belt when
installing the pin.
Feed the belt from the outfeed side
of the dryer, through the top of the
chamber.
Pull the belt through the infeed side
and over the infeed roller.
Run the belt back under the infeed
roller, then above the tension roller
and above the lower support.
Then feed the belt through the
lower portion of the chamber and
out the outfeed side of the dryer.
Lay both ends of the belt flat on
top of the cooling tray.
Now you’re ready to insert the pin.
Line up the yellow marks on the
teeth of the belt.
Push the pin through the teeth
making sure to have the same
amount of extra pin on both sides.
1.
2.
3.
4.
5.
PARTS NEEDED
Belt
Threading Pin
•
•
ASSEMBLY
STEP 4: INSTALLING & TRACKING THE BELT cont.
OUTFEED SIDE
INFEED SIDE
Tension
Roller
Lower
Support
