Woodway Engineering Ltd
Lower Road, Barnacle
Coventry, CV7 9LD
United Kingdom
Tel: +44 (0) 24 76 841750
Fax: +44 (0) 24 76 621796
www.woodwayengineering.com
I N S T A L L A T I O N G U I D E
5
Programming
Reprogramming and the Programming Lockout
Programming Pursuit / Arrival Settings
Programming Strobe Functionality
Programming Momentary Action
Global Reset
Before the unit can be programmed, the programming lockout
must be disabled. Pressing and holding all the switches except
channel 5 will deactivate the programming lockout for 5 minutes.
Whilst the programming lockout is disabled the warning LED will
remain continuously lit. If power is removed, or the unit is put to
sleep the unit will return to the locked mode.
Disable the programming lockout as described above.
When in Pursuit or Arrival mode, pressing and holding the large key, SW7, will allow programming of each mode. The key must be
held for a number of seconds until the blue (Pursuit) or red (Arrival) start to flash. The leds will flash for 30 seconds in which time
the required channels can be switched on/off. After this time the unit will store the new settings. Programming can be cancelled by
pressing the large button again once (reset).
The buttons SW1, SW2 and SW3 can be made self-cancelling in two different ways.
• Self Cancelling
- Only one button can be active at one time.
Pressing and holding the large button, SW7 and SW1 will enable/disable the self-cancelling mode.
• Special Setting
- Operating SW1 only also activates/deactivates SW2 and SW3.
Pressing and holding the large button SW7 and SW2 will enable/disable the special setting.
Any button can be made momentary. This is achieved by pressing and holding SW7 and SW4 until the large button will flash blue
and red. This indicates that the unit is in momentary programming mode. Any channel can now be activated. After 30 seconds, any
channel lit will become momentary.
If the programming needs to be un-done, the unit can be returned to the factory default setup by pressing and holding SW7 and SW3
for 5 seconds.
Key held
Key not held
