10
For Warranty information, please visit ElectroBraid.com
11
Installing Insulators on Corner,
End & Gate Posts
After setting all corner, end and gate posts and correctly bracing them, you are ready to
fasten insulators. Since wood conducts electricity, you must use insulators on all posts,
including brace posts, to eliminate electrical shorts.
Use ElectroBraid
®
Roller Insulators. They are specially engineered:
• To eliminate friction when tensioning
• For safety
• For durability
• For ease of installation
Measure and mark the location of each of your planned strands of Braid
™
on one of your
end posts then make a jig to help you mark your other posts. (A jig is simply a stick on
which you indicate the position of each insulator so you don’t have to measure at every
post).
Attach ElectroBraid
®
Roller insulators by using 2 ½” # 8 rust resistant screws to hold the
insulator in place.
CAUTION - BE SURE NOT TO OVER TIGHTEN
the screws as this
will bend the bracket of the insulator preventing the pin from setting properly possibly
causing the roller to release. Complete the installation of insulators on your corner and
end posts using the jig for spacing
Installing ElectroBraid
®
Roller
Insulators on Corners
The preferred method is to terminate the braid around the back of the post, as shown in
the diagram
