Woodstock SHOP FOX W1667, Инструкция по эксплуатации

Страница: 18 / 36

-16-
To adjust the table, do these steps:
1. Hold onto the table with one hand and
loosen the table lock knob. See
Figure 24.
2. Lift or lower the table to the desired
height, and then position the table so the
opening in the installed table insert is cen-
tered to the drill bit or sanding drum.
• If the table is not needed, pivot the table
to the back side of the column so you can
support the workpiece on the base
(drilling operations only). See Figure 25.
3. Tighten the table lock knob.
4. Loosen the table tilt lock bolt and use the
tilt scale to find your desired drilling or
sanding angle. See
Figure 26.
5. Tighten the tilt table lock bolt.
SUPPORT table before
loosening lock knob.
The weight of the table
combined with the
workpiece could result
in a crushing injury.
You can adjust the table height and angle to
accommodate for workpiece height or achieve
special drilling/sanding angles. You can also
move the table out of the way and use the drill
press base as a table for drilling/sanding.
Figure 24.
Support table while loosening lock.
Figure 25.
Table adjusted behind column.
Figure 26.
Table tilt lock bolt.
Table Tilt
Lock Bolt
Tilt Scale
ADJUSTMENTS
Table Height / Tilt