Woods RC3.5, Руководство оператора

Страница: 23 / 48

Dealer Service 23
MAN1048 (4/16/2014)
SEAL REPAIR
(Figure 15)
Vertical Shaft Seal Repair
1. Disconnect and remove the rear driveline from the
gearbox.
2. Remove vent plug (24) and siphon gear lube from
housing through this opening.
3. Remove crossbar (see Crossbar Removal, page
25 ).
4. Remove output cap (16) and output seal (13) by
removing four cap screws (12) and washers (11).
Replace with new seal (see
Seal Installation,
page 22 ).
Vertical seal should be recessed in output cap.
NOTE: Distortion to seal cage or damage to seal
lip will cause seal to leak.
5. Secure output cap (16) on to bottom of gearbox
using four cap screws (12) and lock washers (11).
NOTE: Make sure output gasket (17) and (18) are
in place.
6. Fill gearbox with SAE 80W or 90W gear lube until it
runs out the side level plug.
7. Remove and replace any seal damaged in
installation.
Horizontal Seal Leak Repair
1. Disconnect and remove the rear driveline from the
gearbox.
2. Remove vent plug (24) and siphon gear lube from
housing through this opening.
3. Remove input cap (2) and input seal (6) by
removing six cap screws(12) and washers (11).
Replace with new seal (refer to
Seal Installation,
page 22 ).
NOTE: Distortion to seal cage or damage to seal
lip will cause seal to leak.
4. Secure input cap (2) on to front of gearbox using
six cap screws (12) and washers (11).
NOTE: Make sure input gasket (8) and (9) are in
place.
5. Fill gearbox with SAE 80W or 90W gear lube until it
runs out the side level plug.
Figure 15 . Cast/Crown Top Gearbox Assembly
1. Housing
2. Input cap
3. Ball bearing
4. Input seal
5. Retaining ring
6. Input seal
7. Retaining ring
8. Input gasket (0.30 mm)
9. Input gasket (0.13 mm)
10. Bearing spacer
11. M10 Lock washer
12. M10 x 1.5 x 25 Cap screw
13. Output seal
14. 1" - 14 Slotted flange nut
15. Cotter pin
16. Output cap
17. Output gasket (0.30 mm)
18. Output gasket (0.13 mm)
19. Shim kit
20. Output gear
21. Ball bearing
22. Retaining ring
23. Input gear
24. Vent plug