Woods RC3.5, Руководство оператора

Страница: 33 / 48

Assembly 33
MAN1048 (4/16/2014)
INSTALL SAFETY SHIELDING
Chain Shielding (Optional)
 Full chain shielding must be installed when
operating in populated areas or other areas where
thrown objects could injure people or damage
property.
• If this machine is not equipped with full chain
shielding, operation must be stopped.
• This shielding is designed to reduce the risk
of thrown objects. The mower deck and protec-
tive devices cannot prevent all objects from
escaping the blade enclosure in every mowing
condition. It is possible for objects to ricochet
and escape, traveling as much as 300 feet (92 m).
The optional chain shielding assemblies are ready for
installation when you receive them.
1. Refer to Front & Rear Chain Shielding, page 42,
and attach as shown by inserting the bolts from
inside the cutter frame out through the shielding.
2. Install hardware as shown in the parts drawing.
FILL GEARBOX
NOTICE
■
Gearbox is not filled at the factory. Prior to deliv-
ery to customer, make sure gearbox is filled only
half-full with 80W or 90W API GL-4 or GL-5 gear
lube. Use side plug to remove any excess oil.
1. Remove solid plug and discard.
2. Make sure vent plug hole is clear.
3. Fill gearbox until oil runs out the side plug on
gearbox. Use a high quality gear oil with a viscosity
index of 80W or 90W and an API service rating of
GL-4 or GL-5.
4. Install vent plug. Use pipe sealant or thread tape
on threads. Plug is shipped in the manual tube.
DANGER