Woods DBH5.30, Руководство оператора

Страница: 42 / 62

42 Assembly
MAN1248 (2/26/2018)
Figure 39 . Cooler Installation
19. Loosely attach inlet and outlet tubes (10 & 11) to
cooler as shown.
20. Loosely attach cooler and tube assembly to
adapters (20). Inlet tube (10) attaches to aft
adapter, outlet tube (11) attaches to inner adapter.
21. Adjust cooler and brackets (9) so that bracket
holes align with cooler at all four places.
22. Assemble four vibration isolators (4 & 5) with
sleeve (6). Attach at four cooler to bracket hole
locations with four fastener sets (1 & 21) as shown.
It may be necessary to rotate brackets and partially
loosen inlet and outlet tube connections so that all
fasteners can be inserted.
23. Tighten four fasteners (1 & 21) so that isolation is
maintained between bracket and cooler.
24. Tighten all JIC connections.
25. Attach hose from motor clamp from step 2 to hose
support above gearbox.
26. Attach bracket (19) to switch on wire harness (18).
Bracket/switch should be installed to owners
preferred location.
27. Plug 7 way connection to tractor. Note: Fuse for 17
amp draw. Switch on cooler fan. Operating
direction is up and away from tank. Reverse
direction as necessary to blow away material from
back of cooler.
28. Check oil level in tank. Fill if necessary so that level
is 5" from bottom of dip stick.
NOTE: Do not operate cooler when oil temperature is
below 50°F. Open bypass valve (17) allowing fluid flow
into tank during cold starts. Operate cooler fan once
temperature is above 50°F. Close bypass valve (17) to
direct all fluid into cooler.
1. 1/4 NC x 1-1/2 HHCS, GR5
2. 1/2 NC x 1-1/4 HHCS, GR5
3. 1/2 NC Flange lock nut
4. Vibration isolator bushing
5. Vibration isolator ring
6. Isolator sleeve
7. Oil cooler
8. Cooler filter bracket
9. Cooler bracket
10. Inlet tube
11. Outlet tube
12. Adapter, 1" JICM x 1" ORBM
13. 1 x 6 Nipple, Sch 40
14. 1" Pipe street elbow
15. 1" Pipe tee
16. Tee, 1" NPTF x F x M
17. Ball valve, 1" pipe
18. Wire harness
19. Switch bracket
20. Adapter, 1" JICM x 1" NPT
21. 1/4 NC Whiz lock nut