Woods DBH5.30, Руководство оператора

Страница: 38 / 62

38 Assembly
MAN1248 (2/26/2018)
Figure 34 . Chain Shielding Installation
Fill Hydraulic Tank
Unit is not shipped from factory with hydraulic oil.
Remove tank cap and fill tank using type "A" or "F"
automatic transmission fluid. Tank capacity is 35 gal
-
lons. Fill to within 5" of dip stick bottom. Based on
ambient temperatures, the following motor oils may be
used:
SAE 30-30W for temperatures above 90°F
SAE 20-20W for temperatures 35°F to 90°F
SAE 10-10W for temperatures below 35°F
Attach Hydraulic Hoses

Air in hydraulic systems can cause erratic oper -
ation and allows loads or equipment components
to drop unexpectedly. When connecting equipment
or hoses or performing any hydraulic maintenance,
purge any air in hydraulic system by operating all
hydraulic functions several times. Do this before
p u t t i n g i n t o s e r v i c e o r a l l o w i n g a n y o n e t o
approach the equipment.
Attach the deck flex cylinder hose and two extension
cylinder hoses to the appropriate tractor ports. Hydrau
-
lic quick couplings are supplied.
NOTE: Always assume it is empty. Fully purge air and
fill the hydraulic system by raising and lowering the
deck plus extending and retracting the extension sev
-
eral times each while hooked to a tractor hydraulic sys -
tem. Keep all personnel away while raising and
lowering.
Driveline
Drivelines for 540 and 1000 RPM tractors are unit
ready. Attach outer sleeve to tractor.

Make sure spring-activated locking pin or collar
slides freely and is seated firmly in tractor PTO
spline groove.

Operate tractor PTO at 540 RPM (1000 RPM on Q
Series cutters). Do not exceed.

Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
Counter Balance
(See Figure 35)
Woods Ditch Bank Cutter can accommodate a variety
of suitcase weights. Refer to Figure 35 to understand
the application. Four counter balance bars (1) are pro
-
vided with five 3/4" fastener sets (2 & 3) to secure one
weight as shown. A fifth fastener set is provided to
secure 2 to 3 additional weights to the first.
1. Remove four bars (1) and five fasteners (2 & 3)
from hitch. A fastener set is located at the top hitch
pin hole.
2. Place a single suitcase weight upon the hitch as
shown. Position the weight such that a maximum
distance is attained from all hydraulic components.
3. Attach four bars (1) with four fastener sets (2 & 3)
to weight and hitch as shown. Torque to proper
specifications stated in the back of this manual.
4. Stack 2 to 3 additional weights upon first weight as
clearance allows.
5. Using fifth fastener set (2 & 3), secure all weights
together as shown. Torque to proper specifications
stated in the back of this manual.
6. Make sure all suitcase weights are secure and will
not shift under operation. Re-tighten after first hour
of service.
1. 3/8 NC x 1 Carriage bolt, GR5
2. 3/8 NC flange lock nut
WARNING
WARNING
CAUTION