Woodley Clinispin Horizon 6 Flex, Руководство оператора

Страница: 7 / 14

Woodley Equipment Company – +44 (0) 1204 669033 – sales@woodleyequipment.com | Page 4
S
INGLE
C
YCLE
L
OCK
Lock on Single Cycle
Select desired cycle. Press and hold the UNLOCK button for 5
seconds. Two beeps will confirm that cycle selection is locked.
Cancel Single Cycle
Lock
To re-enable cycle selection, press and hold the UNLOCK button
for 5 seconds. Three beeps will confirm that cycle selection is now
unlocked.
P
RESET
L
OCK
Enter Settings
Mode
Press the GEAR button.
Lock Saved Cycles
Press and hold the UNLOCK button for 5 seconds. Two beeps will
confirm that the Preset Lock is active.
Cancel Preset Lock
With lid open and while not in Settings mode, press and hold the
UNLOCK button for 5 seconds until two beeps are heard. Saved
cycles can again be edited or programmed.
S
ETTING OR
M
ODIFYING A
C
YCLE
Up to 10 cycles can be named, programmed for time, speed, and braking and saved in memory.
Cycle Selection
Press the up and down buttons next to the screen to select the
desired cycle.
Enter Programming
Mode
Press the GEAR button.
Navigate between
Parameters
Use the left and right arrow button until the parameter to be
edited is blinking and underlined.
Change Parameter
Values
To change the parameter shown on the display, use the up and
down buttons next to the screen.
Displaying the
Correct g-force
Clinispin HORIZON Flex FA only:
To display the real g-force (RCF) for the cycle, the right tube holder
must be selected. Universal blue tube holders accommodate 75
and 100 mm tubes. 125 mm tubes require the orange tube holder.
If the tube holder selection in the program does not match the
tube holder used, the RCF number displayed will not reflect the
actual value.