Sawmill Assembly
Saw Carriage Assembly
Sawmill Assembly
WMdoc122320
3-10
3
1.
Adjust the frame legs so the sawmill appears level; use shims under the legs, if neces
-
sary.
See Figure 3-13.
2.
Run a string from the front bed rail to the rear bed rail near the operator’s side of the
frame. See Figure 3-13.
3.
Place
IDENTICAL
matching spacers between the string and the front and rear bed rails.
4.
Measure the distance between the string and the other bed rails.
5.
Adjust the frame legs until all bed rails measure the same distance from the string.
6.
Repeat the bed rail adjustment with the string at the other side of the sawmill frame.
3.6 Saw Carriage Assembly
1.
Check the orientation of the carriage before placing it on the bed frame; the operator is on
the same side as the log supports.
2.
Position the saw head over the end of the bed frame assembly.
3.
Carefully lower the saw head on the bed frame, sliding the saw head rollers onto the bed
rail while maneuvering the saw head square to the bed to avoid jamming the track rollers.
4.
Remount the mast safety assemblies (right and left) from the transport position to the
operating position. See Figure 3-14.
FIG. 3-13
LX25018-17
Matching
Spacer
Matching
Spacer
String
Measure the distance between
the string and the bed rails