Assembly
Blade Rest Bolt Adjustment
2
2-15
CBNdoc080917
Assembly
2.8
Blade Rest Bolt Adjustment
Standard Blade Clamp
The blade rest bolts can be adjusted for 1”, 1 1/4”, or 1 1/2” wide blades (see below for
1 3/4” and 2” blades). Remove the nut on each rest bolt and move the bolts to one of the
three sets of holes in the clamp plates.
See Figure 2-13.
Use the upper set of holes for 1” blades, the middle set of holes for
1 1/4” blades, and the bottom set of holes for 1 1/2” blades.
Replace the lock nuts. Tighten the nuts only until the back side of the nut is flush with the
end of the bolt.
NOTE:
After adjusting the blade rest bolts, flex the blade support arms up or down as
necessary so the blade will remain level around the complete length of the blade.
FIG. 2-13
Blade Rest Bolt
Lock Nut
SH0014
Choose hole location
for blade size