Assembly
Sharpener Alignment
Assembly
CBNdoc080917
2-12
2
2.6
Sharpener Alignment
Use the LTAGA alignment tool as necessary to achieve accurate alignment between the
blade clamp and the grinding wheel.
IMPORTANT!
Do not attempt to adjust the tool gauge
points. They have been pre-calibrated at the factory to
ensure accurate alignment results.
1.
Make sure the grinder motor is OFF. Cycle the cam until the grinding wheel is at the tip of
the tooth (about to begin face grind).
2.
Remove the grinding wheel cover , oiler assembly and sharpener arbor nut. Remove the
grinding wheel.
3.
Install the alignment tool to the grinder motor shaft as shown.
See Figure 2-10.
Position the tool so all three gauge points are in line with the front
clamp plate.
4.
Install (2) 1/2" SAE flat washers to the motor shaft. Secure the alignment tool and spacer
washers in position with the sharpener arbor nut.
FIG. 2-10
SH0012B
Alignment Tool
Clamp Adjustment Bolt