Wood-mizer EG350EH15S, Руководство пользователя

Страница: 33 / 65

Operation
Edging Operation
Operation EGdoc031621 3-11
3
2. Place the board on the infeed table (A).
3. Set the distance between the blades. To do this, use the cutting width scale located on the front plate
of the press roller housing, or enter the desired cutting width value into the Setworks controller. The
laser sight will show where the blades will travel through the board (”B”)
See Section 4.1 Edger
Controller Panel
for instructions for using the Setworks.
4. Start the blade motors and the belt drive motor. Set the desired feed rate. Push the board into the
edger until the feed system takes the board.
IMPORTANT! If at any time you need to immediately stop the motor
and/or edger operation, press either of the emergency stop buttons.
5. Repeat the above procedure for all boards that will be edged.
6. Shut down the machine when done edging.
FIG. 3-12
!