Setup & Operation
Loading, Turning, And Clamping Logs
Setup & Operation
HD92doc042701
2-15
2
2.9
Loading, Turning, And Clamping Logs
CAUTION!
Be sure the pivot end rails (if applicable), turn-
ing arm, clamp, and toe boards are out of the way before
loading a log onto the bed. Be sure logs are positioned on
the bed so that they will not damage the manual winch
when loaded. Also, be sure the cutting head is moved far
enough forward so the log does not hit it.
To Load Logs
1. Move a log up to the loading arm. Use the manual winch, cant hooks, or loading equip-
ment to move the logs to the foot of the loading arms.
2. Roll the log onto the loader so that it is approximately centered with the sawmill bed. The
log turner will operate much easier if the log is centered on the sawmill bed.
3. Raise the loader lever to raise the log onto the sawmill bed. Simply let the loader rise until
the log rolls onto the mill bed.
4. Lower the loading arm. Leave the loading arm about halfway up while squaring the log.
This will stop the log from rolling off the side of the mill.
NOTE: Logs also may be loaded onto the mill with a tractor or other equipment specifi-
cally designed for that purpose.
5. Flip the clamp into the up position by lowering the clamp lever until the clamp contacts the
flip arm.
