Wonderfire 850, Инструкция для установщика и владельца

Страница: 12 / 24

Method B - Securing with wire.
This method of securing is recommended where the wall / brickwork is in poor
condition or where marble back panels / surrounds are used.
Although this section deals with fireplace openings without a spacer, this method of
securing the heater it can also be used with the optional spacer frame (See method
C).
1.
The fixing kit supplied with the heater
includes a wire and eyescrew. These can be
used to secure the heater to the back of a
surround / fireplace opening.
2.
Mark the eyescrew position on the centre
line at the back of the fireplace opening and at
a height of 565-575mm (See figure 8).
3.
Drill an appropriate size hole in the marked
position.
4.
Insert a wall plug into the drilled hole.
5.
Screw the eyescrew into the wall plug.
6.
Position the heater in front of the fireplace
opening.
7.
At the top of the heater there are four small
holes, two each side of the heater.
From the front of the heater, thread
about 50mm of the wire into the
outside small hole on the right side
of the heater (See point 1 - figure 9).
8.
Thread the other end of the wire
through the remaining small hole to
the left. Continue to push the wire
through this hole until there is only a
small loop of wire at the front of the
heater (See point 2 - figure 9).
9.
At the back of the heater there will
be a long piece and a short piece of
wire coming through the two holes.
Hold the short piece and give the
long piece a gentle tug. This will
secure the wire. Take the long piece and thread this through the eyescrew in the back
of the fireplace opening (See figure 9).
10.
From the back of the heater thread the long piece of wire through the inner small
hole on the left hand side of the heater (See figure 9).
11.
Locate the heater in the fireplace opening, then from the front of the heater, gently
INSTALLER AND OWNER GUIDE
Page 12
©
Baxi Heating U.K. Limited 2010.
Figure 9. Wire fix
Figure 8. Eyescrew location