5-16 How to Setup the Printhead Settings
Rev AB
Wolke m600 touch Operator Manual
How to Adjust Print Registration
If the image does not print in the correct position on the product, then
adjustments can be made.
The
Horizontal Registration
determines the position of the print along the
length of the product.
To change the Print Registration, proceed as follows:
1
Navigate to
Tools > Setup > Printhead > Registration Delay
. The
registration delay screen appears.
Note:
Alternatively, select the print position icon on the home page to access
registration delay screen.
2
Input the required
Registration Delay
. Alternately, use the + or -
buttons (Figure 5-22) to make small adjustments in the parameter
value.
Note:
This parameter is for adjustments of the print along the length of the
product. The start position of the product relative to the product sensor
should be set using the print sensor to print the line gap parameter.
How to Purge Printhead
To purge the printhead, proceed as follows.
3
Touch the
Status Bar
to put the printhead in OFFLINE mode or press
STOP button.
Figure 5-22: Print Registration
Содержание m600 basic
Страница 1: ...Wolke m600 touch Operator Manual P N WLK462324 01 Revision AB March 2013...
Страница 75: ...Rev AB Password Protection 4 21 Wolke m600 touch Operator Manual Figure 4 22 Password Screen...
Страница 153: ...9 2 Technical Drawings Rev AB Wolke m600 touch Operator Manual Printhead Red Figure 9 2 Printhead Dimensions...
Страница 155: ...9 4 Technical Drawings Rev AB Wolke m600 touch Operator Manual Sensor Figure 9 5 Sensor Dimensions...
