Wolf cinema REF-1000, Руководство пользователя

Страница: 44 / 115

44
presentation, if from the Main menu) and accept any changes you may have entered. Settings are saved with the
current channel.
For your situation, you can access any of the individual options in these menus by pressing Menu followed by the
appropriate two‐digit number representing their location in the menu system. For example, press Menu 2‐3 to
quickly access the “Gamma” option in the Image Settings menu. Note that for certain options, you may prefer to
use a “direct key” from presentation level to go directly to a particular option without traveling through the menu
system (available for certain display parameters only).
Before You Begin ‐ Use Quick Setup
For a good and efficient first step in perfecting the image, press Quick Setup . This initiates an automated process
in which the projector quickly optimizes critical display parameters such as size, position, pixel tracking, etc., based
on the type of incoming source data detected. A Quick Setup selection can save considerable setup time, and you
can still modify the adjustments as desired using menu options described below.
Size and Position
In the Size and Position menu, you can increase or decrease
the size of your image, change its proportion (aspect ratio),
move the image to a specific area of the screen, and refine
other related parameters. Use Size and Position controls to
match the image precisely to the screen employed. Changes
made in the Size and Position menu are applied immediately
and are saved when you exit the menu (press Exit or Menu ).
Resize Presets
Select a Resize Presets option to quickly display an image in
its native resolution or to automatically resize an image to
closely fill the projector’s native resolution or to optimize
the width or height of your display. Size, Position and
Blanking parameters will automatically adjust accordingly
or, if Blanking is set first, which defines an Active Input
Area; Resize Preset scaling will occur in this region of
interest only. Resizing options are explained in detail below.
WHAT IS THE RESIZING DEFAULT? By default when displaying a new source, your image will utilize as much of the
projector’s display area as possible for the type of incoming source data, but with minimal or no changes to aspect
ratio. See Select “Default” below.
WHEN “CUSTOM” APPEARS: The “Custom” re‐size descriptor automatically appears in the Geometry and Position
menu when any of the values for Size, Vertical Stretch, H‐Position, V‐Position or Blanking do not correspond to
those for a preset. This option is not offered in the Resize Presets pull‐down list.