Wolf cinema REF-1000, Руководство пользователя, Страница: 23 / 115

23
Figure 2.11 Figure 2.12
5. Fine tune the focus of cross‐hair pattern I by adjusting the appropriate cap screw, see Figure 2‐12 . Adjust until
the cross‐hair image is in focus with minimal flare.
6. Adjust cross‐hair pattern II, by adjusting the appropriate cap screw, see Figure 2‐12 . Adjust until the cross‐hair
image is in focus with minimal flare.
7. Adjust cross‐hair pattern III, by adjusting the appropriate cap screw, see Figure 2‐12. Adjust until the cross‐hair
image is in focus with minimal flare.
8. Repeat step 5, 6, and 7 as required until all 3 cross‐hair patterns are in equal sharp focus. If the boresight is
acceptable, see step 11. If the boresight does not appear to be converging to an acceptable level of image quality
or if the lens will not focus over the correct range of throw distances, then the boresight requires coarse
adjustment, see step 9
9. The original factory boresight can be recovered approximately by positioning the 3 setscrews, see Figure 2‐12 .
Position the setscrews flush with the front face of the lens mount plate and in contact with the inner lens mount
plate, see below Figure 2‐13. This may require adjusting both setscrews and cap screws.
10. If further action is required. Repeat #2.
11. Lock the setscrews, and re‐check the boresight quality. Tighten the setscrew enough to insure they will not
shift.
Figure 2.13
2.2.4 Powering Down
The projector can be powered down by using one of the following methods:
Remote Keypad/Built‐In Keypad
• Press and hold POWER OR
• Press POWER twice OR Figure 2.14