9
4.
Remove the units from packaging
a.
Place the packages on a flat surface
b.
Careful open up and remove packaging
c.
Remove the housing, slide bar and tracks (and 2” x 2” angle if included) from each package
d.
Cut the tape that holds the packaging material that is wrapped around the housing
e.
Remove the plastic tubing from the housing package
f.
Remove hex head screws that attach the housing cover to the housing
i.
Save these screws
g.
Remove housing cover and place it on a flat surface in a safe place
h.
With pliers, remove the c-ring that hold the motor to the end cap
i.
It is important you do not lose the c-ring
i.
Remove roller, screen, pivot and motor by sliding the tube towards the pivot end, compressing the pivot
until the motor comes free from the crown on the end cap
i.
Be careful not to tilt the roller as the motor may easily fall out of the roller assembly
ii.
Place the roller and motor on a flat surface in a safe place
iii.
Take care not to damage the screen that is wrapped around the tube
j.
Reinstall the c-ring around the crown on the end cap
k.
Cut the tape that holds the packaging material that is wrapped around the slide bar and tracks/track
covers (and 2” x 2” angle if included)
l.
Remove the plastic tubing from the slide bar and tracks/track covers (and 2” x 2” angle if included)
m.
Set slide bar, tracks, tracks covers (and 2” x 2” angle if included) aside in a safe place
