11
ii.
Cotter pin fits upwards
c.
Move the motor end of the tube to line up with the crown on the end cap making sure the idler does not
come out of the tube
i.
Ensure the power cord coming out of the motor is facing down
ii.
This is to ensure water does not run in to the motor, otherwise called a drip loop
d.
Line the shape on the motor to the corresponding shape of the crown and connect the motor to the
crown
i.
You must hear a distinctive clicking sound to ensure the motor is completely in place
e.
At the double idler end measure an install locking pins to ensure the tube does not shift
i.
Measure 7” from the front end of the shaft to find Idler B, add ½” and insert 2 screws into in
any of the roller tubes 3 channels to secure Idler B to the roller tube
f.
Loop the power cord around the motor and pull through the opening drilled earlier
i.
If the outlet is towards the bottom of the screen the cord can hang straight down
ii.
A 3/8” hole may need to be drilled in to the track to pull the power cord through
4.
Attach the 3 prong plug to the wires at the end of the cord *plug designs may be different however below lists
the basic rules for installing the plug
a.
Excess cord may be cut if necessary
*Important – when cutting the power cord leave a minimum of 18” of cord between the motor and the end of
the power cord. The antenna for the motor is within those 18” and if cut it will limit the usage of the remote
b.
Using a Phillips screw driver attach the white wire to the silver colored tab, the green wire to the green
colored tab and the black wire to the bronze colored tab
c.
Once all the wires are secure complete plug install by tightening plug cover to plug
5.
Wake up the motor and set the limits *if power is lost before this process is complete the steps will need to be
repeated
a.
Take the remote out of its box and set it to the correct channel if multiple units (remotes come with
battery and are ready to use out of the box)
b.
Plug the unit in to the outlet
i.
Screen will jog up and down
c.
To wake the motor up press the up and down buttons together until the unit jogs up and down
i.
When the motor jogs the unit is woken up
d.
Ensure the motor is rolling the correct way
i.
If you press the down button the screen should move down
ii.
If you press down and the screen rolls up, press and hold the My button until the motor jogs up
and down
iii.
Once the motor jogs press the down button and the screen will roll the correct way
e.
If the screen is still wrapped around the tube, press the My and the down buttons together to set that
point as the upper limit
i.
The screen will begin to roll down
ii.
Hold the middle of the screen material at the zipper and with light pressure helps guide the
screen material down
i.
This is because there is currently no weight on the screen material
f.
Once the screen gets to about 1’ from the lowest point press the My button to stop the screen
g.
Press the My button and the up button together to set the bottom limit
i.
The screen will begin to roll up
