12
h.
Press the My button to stop the screen
i.
Within 6 seconds of stopping the screen press and hold the program button on the back of the remote
until the motor jogs twice
j.
This motor is now programed and can be unplugged if necessary
k.
If the screen is not wrapped around the tube (double idler system install) press the up button to move
the screen up to wrap around the tube
i.
Ensure the zipper is rolling over on itself at the tube on both sides (no telescoping)
l.
When the screen reaches 1’ below the housing press the My button and the down button together to
set the upper limit
i.
The screen will start to roll down
m.
When the screen reaches 1’ from the lowest point press the My button to stop the screen
n.
Press the My button and the up button together to set the lower limit
i.
The screen will start to roll up
o.
Press the My button to stop the screen
p.
Within 10 seconds of stopping the screen press and hold the program button on the back of the remote
until the motor jogs twice
q.
This motor is now programed and can be unplugged if necessary
*Once screen is programmed the My button can be pressed to stop a screen in motion at any point
6.
Install slide bar
a.
Using the up or down buttons on the remote move the screen material to a level where it is comfortable
to slide the slide bar on to the zipper
i.
Use the My button to stop the screen at the desired point
b.
Pick up the slide bar and with the bottom seal facing down slide the slide bar on to the zipper by moving
the screen bottom tag to the side and sliding the zipper through the rounded hole on the slide bar
c.
Continue to feed the zipper through the hole until the slide bar is fully attached to be screen
i.
If installed correctly the zipper will hold to the slide bar
d.
With a Phillips screw driver loosen the 2 screws on both probes (do not take the screws all the way out)
e.
On 1 side of the slide bar fit the probe in to the end with the screws facing out
f.
Move the screen tab in between the screws in the slot on the probe and fit so that the end of the probe
is 1/16” away from the stitching on the tab
g.
Tighten both screws so that the screws puncture the tab and fully attach to the other side of the probe
h.
Repeat for the other side
i.
Line the bottom seal up with one end of the slide bar and cut off the excess material on the other end
i.
The excess material can bunch up within the tracks and cause the obstacle detection to engage
j.
Cut the remaining zipper so that it is level with the bottom seal on both ends of the slide bar
i.
The excess zipper can bunch up at the lower limit and affect where the lower limit is
k.
Press the up button on the remote to move the screen back up to the upper limit
i.
Ensure the zipper is rolling over on itself at the tube on both sides (no telescoping) and make
adjustments as necessary
7.
Install the side tracks and covers
a.
On one side of the screen (left or right) measure from the ground or the lowest point up to the bottom
of the end cap. That is the length of the track
b.
Take the corresponding side track
i.
To find which track goes on which side, take 1 piece of track and face it so that the beveled end
is pointing up towards the housing, the open end (where the track cover will snap on to) is
facing out and the groove for the zipper is facing in towards the other post
ii.
Whichever side matches that lay out is the correct track side
c.
Measure the back side of the track below the bevel towards the bottom end
d.
Mark the length measured earlier
