24
16.
Carefully slide the screen all the way across the roll tube taking care not to damage the screen
17.
When you reach the other side of the roll tube ensure there are equal number of zipper teeth on both ends of
the roll tube so that the screen will be centered
18.
Reset the lower limit back up to just above the original position
a.
Press the up and down buttons on the remote until the screen jogs up and down
b.
After the jog press the up button on the remote until the screen reaches approximately 1’ above the
original position
i.
Ensure the zipper of either side of the roll tube is rolling over on top of itself (no telescoping)
c.
When the screen reaches 1’ above the original lower limit press and hold the My button on the remote
until the screen jogs
d.
A new lower limit is now set
19.
Send the screen up to a comfortable position so that the slide bar can be reinstalled
a.
Press the My button on the remote to stop at that position
20.
Reinstall slide bar and probes
21.
Press the up button on the remote to send the screen back up to the upper limit
a.
Ensure the zipper of either side of the roll tube is rolling over on top of itself (no telescoping)
22.
Reinstall the tracks and track covers
23.
Press the down button to send the screen back to its lower limit
24.
Adjust the lower limit so that screen slide bar bottom seal is approximately 1” above the ground or lowest point
a.
The screen will stretch as it flattens out while hanging
25.
Press the up button on the remote to send the screen back to its upper limit
26.
The screen has been replaced
