2.8
Car installation (isolated platform
support)
(
1
) Lift the car floor (A) onto the fixing plates (B)
of the platform support beams. Adjust the
floor to its place.
The car floor must not touch the uprights.
(
2
) Fit the T-bolt (D) to the car floor channel (E)
and move them to the opening at the fixing
plates.
(
3
) Fasten the car floor against the fixing plates
so that the disk washer (F) becomes fully com-
pressed.
Make sure that the T-bolts are hanging
freely from the openings of the platform
supports!
(
4
) Adjust the car floor horizontally
Secure the car by means of wooden sup-
ports at the front and rear edges.
(
5
) Tighten the nut (G) by hand
(
6
) Install the car walls and the roof.
Car Frame WCS60
Suspension 2:1 / 4:1
Operating instructions
Blatt/
sheet
D389MGB.013
Datum/
date
11.02.2002
Stand/
version
11.02.2002
Geprüft/
approved WAT/FLE
Änderungen vorbehalten!
Subject to change without notice!
(1-
6
)
A
B
G
D
E
F
