2.9
Car installation (non-isolated
platform support)
(
1
) Lift the car floor (A) onto the support plates
(C). Adjust the floor and the plates to its place.
The car floor must not touch the uprights.
(
2
) Adjust the car floor horizontally
(
3
) Fasten the car floor against the support plates
(fasten all the screw joints)
Do not tighten the 4 nuts at the lower
ends of the support now (refer to section
2.11)!
(
4
) Install the ring beams below the car floor.
Needed holes (D=18mm) must be drilled into
the ring beam!
(
5
) Install the diagonal rods
Take care of tightening torque
Screw M12: 80Nm
(
6
) Install the car walls and the roof.
Car Frame WCS60
Suspension 2:1 / 4:1
Operating instructions
Blatt/
sheet
D389MGB.014
Datum/
date
11.02.2002
Stand/
version
11.02.2002
Geprüft/
approved WAT/FLE
Änderungen vorbehalten!
Subject to change without notice!
A
C
(1-3)
(4)
(5)
Nut ... M36
