Subject to change without notice!
EN
HYDRA PLUS UD300 CAR DOOR
Code
Version
Code
Version
Date
Page
GM.2.002668.EN
B
3201.32.0397
B
04.02.2013
12.37
The shoe on the retaining pin is mounted with slight pressure until the proper tongues fit inside the groove (Fig. 1).
For the disassembling it is sufficient to push it from the rear side and at the same time with a small screw-driver to, part the
tongues (1) one after the other.
The shoe mounting and disassembling to the panel is very easy even with assembled panels: in fact it is enough to turn them 90
degrees, put them in a horizontal position (Fig. 2) and pull them towards the outside or push them into the sill’s groove.
The pin’s eccentricity and the presence of the slots allow considerable adjustment.
Fix bottom sliding shoes of the opening side as drawing Fig. 3, so that in case of breaking down of door panel the bottom shoe
can’t fall out from the sill channel.
> 65
> 65
Fig. 1
Fig. 2
1
SINGLE PLATED DOOR
DOUBLE-PLATED DOOR
Fig. 3
6. BOTTOM SLIDING SHOES ASSEMBLY, MAINTENANCE AND REPLACEMENT
Each door must have at least two sliding blocks.
Check during maintenance that sliding guide shoes are present, securely fixed and have impermissible wear.
