8
1. Press one side of the vertical bar so that the cover slides out
(1)
2. Connect the data cable to the bottom of the bar with the metal bundle from the left
vertical bar, pull through holes A and C at the bottom of the left bar.
3. Insert the vertical bar, attach the two M5 screws
(2)
, but do not tighten them yet.
1) Cover for vertical bar
1 x
2) Top screw M10*30
4 x
3) Washer M10
4 x
Attach the connector
(4)
to the left and right bars and tighten with screws (1)
.
Then tighten all screws from step 3.
Please note: When a screw is tightened, use the extension piece (c). Attach it to the end of
the hex key (b) to increase turning momentum.
