Wisenet HCB-6000 HCB-6000PH, Руководство пользователя

Страница: 31 / 41

English_31
●
C
amer
a
Oper
a
ti
O
n
y
DWELL TIME : You can select day/night switching delay time from.
 3s, 5s, 7s, 10s, 15s, 20s, 30s, 40s, 60s
M
`
If you set the AGC mode to off on the exposure menu, you cannot switch the day/night
mode to auto.
`
When a bright light source is in the screen or there are frequent brightness changes, if
you use the auto night/day mode, and set the switching time to short (3, 5 sec), a hunting
can be caused. In this situation, it is recommended to use the default setting (30 sec).
- EXTERN : Ground to the grounding terminal to allow automatic switching between
COLOR and B/W (Black/White).
- COLOR : The picture is always displayed in color.
- B/W : The picture is always displayed in black and white.
You can turn on or off the burst signal on B/W mode.
M
`
If the lens mounted in the camera is different from the one set in <LENS> of the
<EXPOSURE> menu, then the night/day mode may not operate normally.
y
DEFOG : You can use the defog mode to allow the camera to automatically detect
the fog density of the screen and display a clear image despite smog, fog or
general poor visibility.
➊ MM If the SPECIAL menu screen is displayed, use the Function Setup switch so that the
arrow indicates ‘DEFOG’.
➋
MM
Select a desired mode using the
Function Setup switch.
- AUTO : Adjust the level
automatically.
- Manual : Depending on the defog level set by the user, adjust the clarity of image.
(LOW, MIDDLE, HIGH)
- OFF : Released state
M
`
If the defog mode is set to Auto, and if the amount of fog is reduced, the function level
will be also reduced. If you want to maintain the same level of defogging, set it to Manual.
`
If there is little fog and the manual fog level is high, the screen contrast can get high.
DEFOG
▶
1.
LEVEL MIDDLE
2.
RETURN