Wirepath Surveillance WPS-100-NVR-4IP, Инструкция по установке и эксплуатации

Страница: 32 / 70

WPS-100-NVR-4IP Installation Manual
Pg. 32
© 2013 Wirepath™ Surveillance
12.3- NVR Settings
The NVR settings menu is used to assign Cameras to the NVR, configure Camera settings such as
Privacy masks and Motion Detection, configure settings for NVR Recording and Alarms, check status of
and format the NVR HDD(s), and configure System settings.
NOTE that the 4CH NVR has no physical Alarm inputs. So “Alarms” or “Alarm inputs”, as they pertain to
the 4CH NVR, consist of either:

The DI Input of a Wirepath IP Camera (when DI Input (Camera) is Enabled in Alarm Trigger
Setup), or

The Alarm input of a Wirepath Encoder (when DI Input (Camera) is Enabled in Alarm Trigger
Setup), or

In some cases, a Motion event as detected by a Wirepath IP Camera or Encoder.
Any differences in how these alarms or events are handled by the NVR will be specified below, when
appropriate.
Save
Note: A Save button is located in the upper right of all NVR Settings screens. When finished
editing in any screen, the Save button should be selected to ensure the settings are transferred
to the NVR.
12.3.1- Camera Tab
Use to assign and configure Cameras or Encoders used by the NVR.
Camera
(number) Select the NVR channel to view and configure. If no Camera is assigned to the channel, no image will
appear.
12.3.1.1-
Camera Setup Menu
Enable Select to enable the channel on the NVR. If disabled, the channel will not appear in Single or Split Screen.
Mode Select the mode to use for the camera:
Normal
Use Normal for Wirepath™ IP Cameras (recommended).
RTSP
Use RTSP for RTSP-enabled cameras or video sources.
RTSP must be configured on the device.
IP Address
The IP address of the device to assign to the channel.
Port
Port being used by the device.
Username Username used to access the device.
Password Password used to access the device.
Exit
Exits menu without saving changes; Also used to Exit after having saved any changes.
Save
Saves currently entered values to the NVR.
Quick Search
Opens a menu to scan the network for connected devices.
See
12.3.1.2-Quick Search Menu
Connect
Connects to the device entered in the above fields. Provides confirmation of connection success or failure.