WPS-100-NVR-4IP Installation Manual
Pg. 13
www.snapav.com Support: 866.838.5052
6.4- Browser Interface
Note: The NVR requires configuration before accessing for the first time.
See sections
9-IP Installer Software
and
10-Initial Configuration
before
accessing the NVR through the local interface.
6.4.1- Accessing the NVR
Note: IE 8.0 or higher is required to access the NVR; other browsers are not supported at this time.
A.
Open the web browser, and enter the IP Address that was assigned to the NVR. The address should include the
port number assigned to the NVR. Note that access varies between local network and remote access through a
DDNS.
Local Network Example:
http://192.168.1.56:8056
Remote Access (DDNS) Example: http://JonesIPNVR.wirepathdns.com:8056
B.
A window will open asking for a username and password.
Default Username and Password:
Username:
admin
Password:
admin
Recommendation:
After initial setup of the NVR, we recommend that the password be changed to avoid unwanted
access.
C.
Install the ActiveX control if prompted to do so. If the ActiveX installation window does not appear, the IP
address may not be correct. Verify the IP address by using the IP Installer.
D.
After installing the ActiveX the NVR should be visible in the web browser.
6.4.2- Recommendations for Best Performance
As the number of open browser windows or tabs increases, the risk of slowed response time to the NVR increases. We recommend
that open browser windows or tabs be limited to no more than 4 to avoid interruption in communications or reduced response time
with the NVR.
Содержание WPS-100-NVR-4IP
Страница 70: ...2013 Wirepath Surveillance 130409 1721...
