Wireless Devices NetPage NP-14 Series, Руководство по эксплуатации

Страница: 2 / 32

2
INTRODUCTION
The NP-14 Network wireless paging system is a fully-programmable, single-board,
POCSAG encoder with the Hi power synthesized transmitter for every on-site paging
System applications.
The unit provides a combined alarm input and link command paging solution via
either the external computer console , ON/OFF closing contacts, RS232 port, RJ-45
Ethernet port. It is suitable for the industrial alarm and commercial site paging to
obtain a fast response to all kinds of the security problem monitoring situations.
The typical applications include the Fire, Security and Nurse Call System etc fields.
The communication to the transmitter via the RS232 port or RJ-45 port uses a
Common and simple protocol such as the SCOPE, TAP, Comp1, Comp2,….
About the transmission, the NP-14 is a single-board synthesized message transmitter
that operates in the 410-490MHz, 868MHz, 915MHz, 931MHz, frequency bands.
The NP-14 inside encoder contents, which are the capcode, speed and message
Etc, can be sent by the tone-only, numeric(4-bit), alphanumeric(7-bit) using the
POCSAG paging protocol out from either the serial port or from the Ethernet port.
The NP-14 option selection also has 8 ON/OFF contacts for the alarm paging
applications. Each input is an independent port control for the contact input status
either from the open to short or from the short to open. Once the alarm is activated,
the pre-programmed input capcode and message will be sent out immediately. All of
the programming 8 inputs paging carrier must be set in the same set frequency.
Others such as the paging address, data rate, message, repeater call time etc can be
independent either same or all in different.
￭ The NP-14 Alarm contacts up to eight input control lines.
￭ The NP-14 eight contacts input are all independent.
￭ The NP-14 operates can be by the RS-232 serial input.
￭ The NP-14 operates can be by the RJ-45 Ethernet input.
￭ The NP-14 transmitter section is the frequency synthesized unit.
￭ The NP-14 system communication protocol are by SCOPE, COMP2…