Wintriss SmartPAC PRO Servo, Руководство пользователя

Страница: 19 / 228

1147100 SmartPAC PRO Servo User Manual
Chapter 1
– Introduction
19
Chapter 1
– Introduction
SmartPAC PRO Servo is a smart modular interface for multiple press automation functions. With the
same user interface as SmartPAC PRO, which is widely used on standard mechanical presses,
SmartPAC PRO Servo tracks the position of the ram using a linear transducer instead of a resolver.
“Ram Position” settings for top and bottom linear position (see page 154) determine the stroke length
for each tool, which is converted to 0° to 180° for the downstroke and 181° to 359° for the upstroke.
Ram Position must be programmed properly for SmartPAC PRO Servo to work correctly.
CAUTION
Some Servo presses are capable of hitting the same part more than once at Bottom Dead Center
(BDC) before returning to the top of the stroke. You will have to note the angle ranges at which
repeated strokes occur. Any cams programmed within these ranges will actuate once for each hit.
Die protection ready signals programmed within these ranges will expect sensor actuation once for
each hit. If this is not feasible, please contact Wintriss Tech. Support to learn about new advanced
features.
Failure to comply with these instructions could result in property damage.
NOTICE
If this is a retrofit, do not disconnect existing linear and pressure sensors from your control.
Installation instructions. Identify the old inputs from which sensors are disconnected and the new
inputs to which they are connected.
Figure 1-1. SmartPAC PRO Servo Front Panel