Wintriss ShopFloorConnect SMI 2, Руководство по установке

Страница: 30 / 44

1146400 SFC Machine Interface (SMI 2) Installation Manual
30 Chapter 2
– Installation
Figure 2-10. Forced Downtime Menu Screen
7. When you are finished, reset the Forced Dialog Mode to Enable w/Auto and the Forced Dialog
Timer to 180 seconds, the default setting, or to a different setting of your choice.
Checking Ethernet Connectivity
To check that SMI 2 is properly connected to your Ethernet, do the following:
1. Verify that the green link LED is lit solid and the amber LED is rapidly flashing. These LEDs
are located on either side of the Ethernet (RJ45) connecter, with the green on the left side and the
amber on the right side.
2. If one or both of these LEDs are not lit, check the connection between your Ethernet cable and
the Ethernet connector.
3. If the Ethernet cable is properly connected, but one or both of the LEDs still do not come on, call
Wintriss ShopFloorConnect Technical Support.
Setting the IP Address, Subnet, and Default Gateway
You must set the SMI 2’s IP address, subnet, and default gateway for the unit to communicate with
SFC.
1. On the Main screen, press Setup . The Setup screen appears.
2. Press
Additional Settings
. The Additional Settings screen appears.
3. Press
Network Settings
. The Network Settings screen appears.
4. Press Network IP Settings . The Network Menu screen appears.
The factory default IP address (192.168.100.225), subnet, and default gateway must be changed to the
static IP address programmed into ShopFloorConnect for the machine (refer to your
ShopFloorConnect Workbook for the proper IP address for each machine).