Wintriss ShopFloorConnect SMI 2, Руководство по установке

Страница: 22 / 44

1146400 SFC Machine Interface (SMI 2) Installation Manual
22 Chapter 2
– Installation
Connecting Input Wiring
Figure 2-6. SMI 2 Control Board
You can make up to four input connections to the SMI 2:
•
Machine cycle input
•
Run/idle input
•
Scrap input
•
Setup mode input
These wiring connections are made on the series of terminal blocks (connectors) labelled TB2, TB3,
and TB4 located along the bottom edge of the left side of the SMI 2control board (see Figure 2-7,
page 23).
You must wire either a Cycle or a Run/Idle input in order for SMI 2 to detect that the machine is
running. If you want SMI 2 to also count parts, you must wire the Cycle input. The Scrap input
should be wired if you want SMI 2 (or the machine operator) to be able to increment the scrap part
counter. Wire the Setup mode input if you want SMI 2 to maintain the current machine state and
suspend counting of parts during machine setup.
F1
Fuse
SD Card
BT 1
Lithium Batt
SOM Module
DS26 - 24 V
DS28 - 12 V
DS25 - 3.3V Logic
DS20 - 3.3V VDD
PROC
Network
Jack
Link 100
Act
K1
Inhibit
Relay
DS19 - 1 GB DS18 - 10M
PS1
PROC
DS27 - 5V
SOM
Power
DS10 - TX Serial
DS9 - RX USB Act
DS12 - TX USB Comms
DS11 - RX Serial
DS21 - Touch Panel
TB2
TB3 TB4 TB5
DX
16
RX DX
15
TX