Wintriss ShopFloorConnect SMI 2, Руководство по установке

Страница: 29 / 44

SFC Machine Interface (SMI 2) Installation Manual 1146400
Chapter 2
– Installation
29
Figure 2-9. Forced Dialog Settings Screen
3. On the Forced Dialog Settings screen, make sure the status message below the
Forced Dialog
Mode button is “Enabled w/Auto,” the default backfill setting. If the status is “Disabled” or
“Enabled w/ Auto,” press
Forced Dialog Mode
to change the message to “Enabled w/Manual.”
4. The time interval displayed below the Forced Dialog Timer button should be “180 Sec,” the
default setting. You can set it to a different interval (e.g., 60 seconds, 600 seconds, etc. up to a
maximum of 3600 seconds) by pressing
Forced Dialog Timer , which displays the Forced Dialog
Timer screen. The current timer setting is displayed at upper right.
5. To test the output wiring, decrease the Forced Dialog Timer setting to 30 seconds by pressing the
3
key and the
0
key(the number at upper right changes to “30”), then press
Enter
.
6.
You are returned to the Forced Dialog Settings screen with the setting “30 Sec” displayed below
the
Forced Dialog Timer
button.
•
If your machine inhibit output wiring is correct, you should be unable to restart the machine
after 30 seconds have elapsed and the Forced Downtime Menu screen, Figure 2-10 has
displayed.
•
If you can restart the machine after 30 seconds have elapsed, check the machine inhibit
output wiring.
•
If the machine inhibit circuit is wired correctly and you are unable to prevent the machine
from restarting after the forced dialog time, call Wintriss ShopFloorConnect Technical
Support.