Wintriss dipro 1500, Руководство пользователя

Страница: 89 / 129

Using DiPro 1500 in Program mode
DiPro 1500 User Manual 80 Ch 5 1092000
Set counters
To set counters for a tool number, select "Program/load tool numbers" from the
programming menu (the first display in Program mode). Select the tool number,
then select "Set counters". You will see a display like this:
COUNT PRESET VALUE
BATCH
PRESS ENTER TO SET COUNTER
PRESS RESET WHEN DONE
TOTAL HITS
USE CURSOR KEYS TO MAKE SELECTION
GOOD PARTS 0 0
0
0 0
The good parts counter counts all good parts up to the preset value (all the parts you
plan to make). It does not count parts for a stroke where a malfunction occurred.The
batch counter counts the same parts. It can be used to signal the end of a batch so a
bin or chute can be changed. When a counter's preset value is reached, DiPro signals
the press to top stop.
The total hits counter counts all hits on a tool. If the tool number is loaded again
after other tools are used, the counter starts counting from the last recorded number
for the previous job. The counter is useful for deciding when a tool needs regrinding.
To reset the parts or batch counter:
1. Highlight the number under "count" you want to reset. Press ENTER to
select. The counter goes to zero.
2. Press RESET to go back to the previous display.
To reset the hits counter:
1. Highlight the number displayed in the "count" column and press ENTER.
2. You will see this message: "PRESS THE RIGHT-ON KEY IF YOU REALLY
WANT TO CLEAR THE TOTAL HITS COUNTER. PRESS RESET IF YOU
DO NOT". Press the right ANGLE-ON key to reset the counter to 0. Press
RESET to go back to the counter display without resetting the counter.
To preset the good parts or batch counters:
1. Highlight the preset value for the counter using the cursor keys. Press ENTER.
You will see the display allowing you to enter a number for the counter.
2. Enter a number using the cursor keys. See "Entering a number with the cursor
keys" in Chapter 3 for step-by-step instructions for entering a number.
3. Press ENTER when done. You will see the new preset value on the counter
display. (You can press RESET and go back without entering a number.)
NOTE
:
You can disable counters by setting the preset value for the good parts
and batch counters to zero. Also, counters are automatically disabled in "setup
mode". For more information on setup mode, see "Wiring a remote reset
switch or setup mode disable circuit" in Chapter 2.