Wintriss autoset 1500, Руководство пользователя, Страница: 38 / 102

1137200 AutoSet User Manual
2-18 Installation
3.
Mount the LMCS sensor on an adjustable bracket so the sensor is positioned 3/8” to 1/2”
from the face of both magnets (see Figure 2-13). The LMCS sensor is shipped mounted
on a slotted bracket with slots 1.5” apart and approximately .1875” (3/16”) wide by .75”
(3/4”) long. Use size 6-32 hardware and lock washers.
4.
Open the cover of the AutoSet enclosure, and locate terminal block TB101B (AutoSet
1500 and 1500 Plus) or TB101A (AutoSet 1504 and 1504 Plus) at the lower left of the
AutoSet processor board, referring to Figure 2-4 or Figure 2-5.
5.
Run the cable from the LMCS sensor through flexible, liquid-tight conduit to the bottom
left knockout on the AutoSet enclosure or to the appropriate location on your console.
Measure and cut the cable so it reaches TB101B or TB101A easily.
The AutoSet enclosure is rated NEMA 12 (protected against dust and oil). If you ordered
the enclosure, you must use conduit rated NEMA 12 and make proper conduit connections
to ensure NEMA 12 protection.
6.
Remove the connector from the TB101B or TB101A terminal block, and connect the three
wires from the LMCS sensor cable, as shown in Table 2-6, page 2-19.
Refer to Figure 2-7, page 2-9 if you need help connecting the wires to the terminals.
Make sure not to wire the connector backwards.
Figure 2-13. LMCS Installation
Make sure to position the LMCS sensor at least 3/8 in. away from the magnet. If the
sensor/magnet gap is too small, the sensor will actuate two times per stroke, causing zero
tonnage displays and, potentially, repeatability faults.
NOTICE