PPM-C412/Configuration
v1.0
www.winsystems.com
Page 33
Layout and Pin Reference
Fast Ethernet
A DMP Vortex Ethernet controller chip is used for high-speed data transfer. It has
auto-negotiation capability for speed, duplex and flow control. It supports IEEE 802.3
10Base-T and 100Base-T.
The Ethernet interface is provided at Multi-I/O connector
J7
, which is an 80-pin high
density connector. WinSystems offers the cable CBL-251-G-1-1.5 to simplify the
connection. This cable is included in the cable set CBL-SET-412-1.
The D1 and D2 LEDs provide a visual indication of the link status, network activity and
network speed. The yellow Link/Activity LED at D1 is lit when a valid connection is
detected and blinks when activity is detected on the wire.The red LED at D2 is on if a
100Base-T link is detected and off if a 10Base-T link is detected.
Ethernet activity signals are also provided at connector
J7
to allow optional status LEDs
to be mounted off-board. The Ethernet activity signals are active low and require an
external resistor to limit current to 12-16 mA.
7.12.6 J103 10/100/1000 Mbps Ethernet
An Intel I210 32-bit PCIe Gigabit Ethernet controller chip is used for high-speed data
transfer. It has auto-negotiation capability for speed, duplex and flow control. It
supports IEEE 802.3 10Base-T, 100Base-T, and 1000Base-T.
Pin
Assignment
Pin
Assignment
1
X axis direction
14
Spindle off
2
X axis movement
15
Spindle speed up
3
Y axis direction
16
Spindle slow down
4
Y axis movement
17
E-Stop 1
5
Z axis direction
18
E-Stop-2
6
Z axis movement
19
Signal function 1
7
X axis max limit
20
Signal function 2
8
X axis min limit
21
Signal function 3
9
Y axis max limit
22
Ground
10
Y axis min limit
23
Ground
11
Z axis max limit
24
Ground
12
Z axis min limit
25
Ground
13
Spindle on
