13
www.winstonind.com • 800-234-5286
hold & serve drawer
7. Use pipe cleaner or spring to gently clean out the trough drain hole (see Figure
2 below). Be careful not to push too hard or you may damage the plastic tube
that connects to the drain (hidden). If using a pipe cleaner, be sure to bend the
end back on itself so the sharp edge of the wire in the pipe cleaner is not
exposed.
CAUTION:
Damaging the plastic tubing will lead to a leak inside the appliance.
8. Inspect heating elements (if exposed). The heating elements are made of
stainless steel. If cleaning is needed, scrub with a Teflon
™ or nylon bristle brush
to remove heavy food particles. Further cleaning may be done with a plastic
scouring pad and alkaline based cleansers. DO NOT use wire brushes,
scrapers, steel wool pads or chloride based cleansers. Follow cleanser
manufacturers instructions for use on stainless steel. Rinse well several times
with clean water and wipe immediately.
9. Rinse all inside surfaces, including evaporator, and dry with clean towel.
CAUTION: Do not spray controls or outside of appliance with water.
10. Replace drawer(s).
11. Verify O-ring is on drain pipe, replace drain cap, and refill evaporator.
12. Reconnect appliance to electrical power and make ready for use.
Figure 1 - Clean scale from evaporator.
Figure 2 - Clean trough with pipe cleaner.
daily cleaning